Description
Glow Worm phosphorescent powders can be added to Smooth-On liquid plastics, rubbers, and foams to create castings that glow in the dark after being charged with light. Glow Worm powders are up to 50% brighter than other similar products!
For best results, use Glow Worm powder with fast-curing transparent resins, such as Smooth-Cast 325. Fast-curing resins ensure an even distribution of the powder filler throughout the casting process. If the resin system is too slow, the filler may settle unevenly in the finished casting. Glow Worm powders can also be added to transparent silicone rubbers, such as Dragon Skin or Ecoflex, which are soft and flexible.
USAGE: Recommended mixing ratio by volume: 1A + 1B + 1 part Glow Worm powder.
Before adding the powder, carefully mix components A and B with liquid resins, gums, or foams. Thoroughly stir the powder (~30 seconds) into the two-component liquid resins or gum until a uniform consistency is achieved.
INSTRUCTIONS: Glow Worm powder must be stored dry! All powders absorb atmospheric moisture over time, which will react with urethane resins. If you notice a moisture reaction between the resin and powder or suspect that your Glow Worm powder contains moisture, you can correct it by evenly spreading the powder on a sheet of foil 0.6 cm thick and baking it in the oven for 4 hours at 60 °C. Allow the powder to cool before mixing with resins. Store the powder in a tightly sealed container in a cool, dry place.










Reviews
There are no reviews yet.